How long has shed had the current one attached?
Sometimes they take a few days to settle down.
Also, I have had an alarm overnight when I was leaning (sleeping) on the sensor and it went very low.
Came back up to a reasonable value over the next few minutes.
The Libre cannot be trusted to be accurate (always check readings with a finger prick if you are concerned) but is very good at showing trends.
It is generally good to check each new Libre after a couple of days to see if it is reading low, high, or just about right.
The most common reasons for Libre to be out are
- compression lows. Sensors will report low if you apply pressure to them. This is possible if your wife was lying on the sensor and something to consider when placing a new sensor - avoid placing it on the part of the arm that she lies on.
- bedding in. Our bodies can react to having an alien object inserted in our arm which results in inaccurate/random/noisy readings. I find my body takes at least two days to get used to a new sensor. Therefore, I insert it two days before activating it. So, for two days, I have an active sensor in one arm and another one getting familiar with my body in my other arm.
- when levels are rising or falling quickly. Libre (and CGMs) use readings from Interstitial Fluid to estimate out blood sugar levels. Interstitial fluid can be 15 to 20 minutes behind finger pricks. Abbott have updated the algorithm it uses in Libre 2 to attempt to take this delay into consideration by "predicting" the value. If levels are changing quickly or noisy, this prediction algorithm is less effective.
- highs and lows. Libre is most accurate between about 4 and 8mmol/l. It can over-report highs and under-report lows. Therefore, it is strongly recommended to always double-check a high or low reading before making any corrections. And always keep finger prick meter with you - you never know when Libre may fall off or need a double check. In the UK, I believe it is a DVLA requirement to have a finger prick meter with you at all times when driving.
- faulty sensors. Some sensors are just faulty. This is not that common but some people do experience problem sensors that need to be reported to and replaced by Abbott. Generally, Abbott are pretty good at replacing faulty sensors.
3.3mmol then after 5 min 3.1mmol. I found it unusual so I decided to do a finger test as we are at home. To my surprise, the finder reads 7.0mmol!!
The Libre is always a bit behind a finger prick, so this looks like she was simply rising quite quickly and the Libre hadn't catched up yet.5 minutes after, Libre is reading 4.8mmol, now 5.5mmol,
As mentioned previously, the Libre 2 algorithm is much better than the Libre 1 algorithm with regards to handling the delay. With Libre 2, it predicts the value 10 minutes ahead. Sometimes you can spot this when the value reported at the time of a scan disappears in the future when the trend direction changes before the peak.The Libre is always a bit behind a finger prick, so this looks like she was simply rising quite quickly and the Libre hadn't catched up yet.
Not my experience. For me the Libre2 still takes a long while to notice I've been out of a hypo for 20 minutes already.As mentioned previously, the Libre 2 algorithm is much better than the Libre 1 algorithm with regards to handling the delay. With Libre 2, it predicts the value 10 minutes ahead. Sometimes you can spot this when the value reported at the time of a scan disappears in the future when the trend direction changes before the peak.
Not my experience. For me the Libre2 still takes a long while to notice I've been out of a hypo for 20 minutes already.
If it senses a hypo, or a hypo coming on, it cannot know if I treated or not so it would be impossible to predict I'm going up when my interstitial fluid is still on the low side.
Correct. It can only predict if the trend is following the same approximate lineNot my experience. For me the Libre2 still takes a long while to notice I've been out of a hypo for 20 minutes already.
If it senses a hypo, or a hypo coming on, it cannot know if I treated or not so it would be impossible to predict I'm going up when my interstitial fluid is still on the low side.
As mentioned previously, the Libre 2 algorithm is much better than the Libre 1 algorithm with regards to handling the delay. With Libre 2, it predicts the value 10 minutes ahead. Sometimes you can spot this when the value reported at the time of a scan disappears in the future when the trend direction changes before the peak.
Reading back, I see I reacted to what I thought you wrote, and not exactly to what you actually wrote, so I wasn't reading properly either.I guess I did not explain myself properly.
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?