• Guest - w'd love to know what you think about the forum! Take the 2025 Survey »

Conrol Test Solution

S

Sparks1224

Member
Messages
9
Hello To All,
New on so sorry if this has been asked or covered.
I am currently using an Accu Chek Performa Nano and cannot find any Control Test Solution.
Is there one available and are specific test strips needed and if so how often should a control test be done.
Thanks,
S.
 

Usually phone manufacturer's customer services and they send it out to you F.O.C.

As to frequency, it's difficult to say. I've done it once in the past 5 years, then my control solution expired.

But if you feel the need to check what your meter is telling then go ahead.
 
Did you register your meter with Roche when you first had it? I did for my Aviva Nano and get free control solution - which lasts 3 months and battery vouchers from them which they post to me f.o.c. They used to send batteries until some one decided it wasn’t safe
 
Antje77 said:
Hi @Sparks1224 , and welcome to the forum!
I've never done a control test, instead I check my meter against my diabetes nurses when I'm there, or against my own spare meter.
Click to expand...

Would that be wise, checking one meter against another with the 15% allowance? Control solution is specially made to read at a certain level on the machine. I always tell people to stick to one machine as the variances in the machines can be way out.... ie an actual BG of 7 could be 5.9 on 1 machine and 8 on the next
 
porl69 said:
Would that be wise, checking one meter against another with the 15% allowance? Control solution is specially made to read at a certain level on the machine
Click to expand...
The control solution has a +/- 15% range.
 
porl69 said:
BUT it gives you what your meter should be reading?? ie 7-8. Comparing 2 meters can potentially be nearly 25% out
Click to expand...
Correct, I was just pointing out that control solution just shows the meter (actually the particular batch of strips) is in range, rather than measuring the accuracy.
 
porl69 said:
Would that be wise, checking one meter against another with the 15% allowance? Control solution is specially made to read at a certain level on the machine.
Click to expand...
I allow for such differences. when comparing meters. As far as I understand the control fluids aren't supposed to give you an exact number either, the meter is deemed right when the result is between certain numbers.
 
I don't bother these days, personally. Waste of a good strip. So far I've never had cause to question the validity of a measurement.
 
You must log in or register to reply here.
Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn More.…