Thanks - that is helpful. IOB reading has been zero when I start but, agree, that is unlikely to be right.Hi.
If you're going low you must still have some IOB.
For planned exercise I'll stop the delivery of all insulin at least 2 hours before and watch my cgm until I start to see it rise steadily. Then I will restart my basal at 10 - 15% for the duration of exercise. It's not perfect but the best I've worked out.
If it's an unplanned exercise I'll have to eat some rapid action carb.
Thanks, agree that prior basal insulin could be a factor.If your insulin lasts 3 hours, this includes the insulin you use for your basal. Therefore, if you remove your pump 90 minutes before starting exercise and you say you calculate that NovoRapid remains active for 3 hours, you still have 90 minutes of your basal in your body.
Thanks - my experience seems very similar to that. I found Exercise Mode on the pump ineffective when using Control IQ. Will try your approach.I also use the Tandem Slim and Control IQ - I have found even with no active IOB that I still go low despite using exercise mode in going for 40+ mins on a run, I now turn off Control IQ an hour before I go out and make sure my levels are above 9 mmol/l and I now barely skirt above hypo levels so will drop to around 4.5 mmol/l, I always carry glucotabs so when I see the arrow going down below 6 I just neck 3 tabs - touch wood that is working ok for me.
Sadly it is my only complaint with the Tandem that it can't cope with exercise mode, just remember to set an alarm reminder to turn Control IQ back on though as sometimes I forget to do this for a few hours which doesn't help ! Let me know how you get on as would be useful to see how you cope with this ?Thanks - my experience seems very similar to that. I found Exercise Mode on the pump ineffective when using Control IQ. Will try your approach.
Hello everyone,
I am a Type 1 diabetic and use the Tamdem T-Slim x2 pump with Novorapid, diagnosed in 2011. I have only had the pump since June, going well but am still getting used to it. I have a query that I hope someone can help with.
One of the benefits I had anticipated from having the pump is that I could stop it giving me insulin when I wanted to exercise and that this would prevent my BGs going too low. I was previously using Tresiba as my long acting insulin and that meant I would always have to take on quite a lot of sugar before, for example, a 45 mins run.
I have tried taking the pump off entirely an hour and half before exercising (and have no insulin on board) but have found that my sugars still go very low after about 20mins of running so that I have to take on sugar to recover. Any idea why this happens when I have no insulin in my system?
Thanks
Thanks, will report backJust like you, I have a Tandem T-Slim X2 and have also been on it since June.
I've found a pretty good strategy with a morning run but this may not work for you. As soon as I wake up, I set the temporary basal rate to 80% and set the time period to two hours. I think last time I did three hours, as an experiment. As long as my reading is 6 or 7, it basically ends up back there at the end of the run. It rises a bit at the start, then goes back down into range.
Recently I did a park run, adopting the same strategy. It was 7.3 just before the run began and 7.3 when I finished.
I haven't found a reliable strategy for evening runs, though. Both times I've tried that on the pump, I've gone low. The solution is probably in using a lower basal rate like 60% and perhaps having a small snack before the run.
How did you set up a timed temporary basal rate?As soon as I wake up, I set the temporary basal rate to 80% and set the time period to two hours. I think last time I did three hours
How did you set up a timed temporary basal rate?
Yes, my pump is t:slim X2. I have been using it since May last year. The manual says that, to use a Temp Rate, Control-IQ must be turned off. I was wondering if you had managed to set a Temp Rate with Control-IQ. (Temp rate was so simple with my previous pump Accu-Check Insight.)I have the T-Slim X2. Do you have this as well?
Yes, my pump is t:slim X2. I have been using it since May last year. The manual says that, to use a Temp Rate, Control-IQ must be turned off. I was wondering if you had managed to set a Temp Rate with Control-IQ. (Temp rate was so simple with my previous pump Accu-Check Insight.)
I just go to Options > Activity >Temp Rate. Then you put in a percentage and how long you'd like it to be at that rate.
Thank you.I just go to Options > Activity >Temp Rate. Then you put in a percentage and how long you'd like it to be at that rate.
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?