Libre Sensor 2 plus sensor

[PMb1]

Has anybody had a sensor fall apart or looks like 2 sensors together.
See picture attached
This has just happened to me but I can't praise Abott enough when I complained.
Sending me a new one as a priority.

 

[Jaylee]

Hi,

It’s not clear on the picture.
However, there has been the odd case where the hole punch from the applicator that buries the filament has not retracted & broke off.. which is what I can make out from your images..?

Are you suggesting there were 2 sensors stacked in the applicator?

 

[jaywak]

Like Jaylee has said it looks like the punch has not aligned properly and instead of penetrating your skin it has pushed back and broken the sensor apart , I have had it happen once , not as dramatic as breaking the sensor apart but pushing the punch and filament to a angle , I just phoned Abbot and they replaced it .

 

[PMb1]

Hi not sure but when applied sensor it seemed like sensor attached as normal but then I saw in the applicator another bit was left with a small screw sticking out and another needle.
But would not scan.
Abott we're replacing.
This is the second one that failed in succession the other one said replace sensor everytime I scanned but was still giving reading.

 

[Jaylee]

Hi not sure but when applied sensor it seemed like sensor attached as normal but then I saw in the applicator another bit was left with a small screw sticking out and another needle.
But would not scan.
Abott we're replacing.
This is the second one that failed in succession the other one said replace sensor everytime I scanned but was still giving reading.

I have heard cases of the “hole punch” being left in after application, it’s meant to retract but somtimes breaks?
. @urbanracer had it happen?