• Guest - w'd love to know what you think about the forum! Take the 2025 Survey »

Setting up new shuggah

H

holdem

Well-Known Member
Messages
164
Hi I seem to have this issue every time I set up a new freestyle libre 2 on Shuggah.

I do this

I delete my old sensor
I set the new one up on the freestyle app.

I then set up Bluetooth connection for new sensor. But I get this screen so many times where it says “
Sensor Scan Successful!

Scan successful

Click OK and just wait to allow the sensor to finish connecting via bluetooth.

In a short while the status should change to 'Connected'.

nning

OK”

Is there any tips to make the set up easier as I just sort of keep trying about 60 times and it eventually connects
 
bump
2 weeks later setting up another one. stuck in a loop of repitition.


Does anyone have any tips.

Thanks
 
Just put a new sensor on then scan it comes up with something like new sensor found tap connect or continue then scan again it starts the timer then 2 hours later it’s working or that’s what I use to do most of the time hope that you can make sense of what I’ve said
 
Ah ok so its a 2 hour wait. i will try this next time. Maybe this is what is happening but my impatience means i keep trying to set a new one up. Thanks for the reply.

Cheers
 
I do this every 2 weeks
Start a new sensor on freestyle app, when it’s ready (after 60 minutes) & I get a reading I delete freestyle libre app & start the sensor on shuggar (usually takes 3 or 4 attempts) when it’s working I go back to the App Store & redownload freestyle 2, log back in & scan sensor to get a reading
They should then work at the same time, any problems turn Bluetooth off to phone wait a couple of minutes & turn it back on again
Good luck
 
ok thanks will try this too

thanks

I find it so frustrating every 2 weeks.

I love shuggah its amazing but the set up each time is frustrating.

thanks
 
The advice I have followed the advice on other forums is as follows and seems to work on my IPhone 10 -
1. Delete the earlier Bluetooth link to the sensor.
2. Turn off and then restart your IPhone ( step 2 would seem to wipe previous hidden info, to enable the next step.
3. Set up new Bluetooth link to the new sensor in the usual way. This may require 1 or 2 attempts.

It would help if the Shuggah al could enable this more simply tho’.
 
Joe9 said:
The advice I have followed the advice on other forums is as follows and seems to work on my IPhone 10 -
1. Delete the earlier Bluetooth link to the sensor.
2. Turn off and then restart your IPhone ( step 2 would seem to wipe previous hidden info, to enable the next step.
3. Set up new Bluetooth link to the new sensor in the usual way. This may require 1 or 2 attempts.

It would help if the Shuggah al could enable this more simply tho’.
Click to expand...
You are a superstar. Sorry only just seen this and coincidentally have been trying to set a new one up since 9 am. Read this and it works.

thanks
 
Back
Top